Intended Use; Operating Instructions - Worx WG263E Series Manual

VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 62841:
Vibration emission value:
Front handle a = 1.59 m/s
h
Rear handle a = 1.56 m/s
h
Uncertainty K = 1.5 m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may
be used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
Cordless Hedge Trimmer
2
2

4.INTENDED USE

The machine is intended for cutting and trimming
hedges and bushes in domestic use.
5.OPERATING INSTRUC-
TIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Installing and Removing the battery
pack
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger's
manual.
OPERATION
Starting and stopping
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until all
damaged parts have been replaced or
repaired. Failure to do so could result in
serious personal injury. DO NOT USE
WITHOUT FRONT HANDLE AND
SAFETY GUARD.
Side cutting
Lubricating the Cutting Blade
Remove the battery pack from the
trimmer.
Place the trimmer on a level surface.
Apply some lubrication oil along the
edge of the blade.
It is recommended to oil the machine
after using your hedge trimmer for an
extended period.
WARNING: Do not oil the blade when
the trimmer is running.
FIGURE
See Fig. A
9
See Fig. B1,
B2
See Fig. C
See Fig. D
See Fig. E
EN