Table of Contents
Advertisement
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
4. INTENDED USE
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
5. OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
40V Cordless Hedge Trimmer
FIGURE
See Fig. A
WG286E WG286E.X
Assembling the front handle
NOTE : The handle is designed to
prevent being assembled in wrong
direction . If you find it cannot be
installed, please turn it around.
Assembling Hedge Sweeper
NOTE:To avoid clippings and other
debris to fall back into the hedge,
you can use the Hedge Sweeper to
sweep the cuttings off the hedge.
You can operate the machine with or
without Hedge Sweeper according to
different working conditions.
Checking the battery charge condition
NOTE : Fig. C only applies for the
battery pack with battery indicator
light.
Charging the battery pack
NOTE :
•
The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
•
Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Installing and Removing the battery
pack
NOTE :
•
This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
•
When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
ower indicator light
P
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the trimmer may still
be capable of hedge trimming.
Continuing to operate your trimmer
with the battery in this discharged
condition may reduce the life and
performance of your battery.
When no light is illuminated, at least
one battery is not fully installed or
battery may be defective, please
double check the batteries are fully
seated into position.
See Fig.
B1, B2
See Fig.
C1,C2
See Fig. D
See Fig. E
11
See Fig. F
See Fig. G
Advertisement
Table of Contents
