ResMed Mirage Micro User Manual page 5

Fitting the Mask
1
Turn the dial, so that the
forehead support is fully
extended.
4
Unfasten the Velcro
pull the upper headgear
straps evenly until they
are comfortable and firm,
and reattach the Velcro.
7
Lie down in your sleeping
position. Adjust the dial
until the mask is evenly
positioned on your face.
It should be comfortable,
with an effective seal.
Adjust the headgear
straps if necessary.
2
Hold the mask over
your nose and pull the
headgear over your head.
5
, Repeat step 4 with the
®
lower headgear straps.
8
The fitted mask is shown
above.
3
Bringing the lower straps
below your ears, connect
the headgear clip to the
the mask frame.
6
Connect the main air
tubing to the swivel. Then
connect the free end of
the air tubing to your flow
generator and turn the
flow generator on.
Removing the Mask
Disconnect one of the
headgear clips and pull
the mask and headgear
up over your head.
3