Table of Contents
Advertisement
https://appliancetechmanuals.com
Lower O ven Section
REMOVIN G TH E OVEN LIGH T SW ITCH , TH E OVEN
DOOR LATCH ASSEMBLY, & TH E H I-TEMP CUTOUT
WARNING
Turn off the electrical power circuit to the
oven at the main junction box before ser-
vicing this unit.
CAUTION
W hen you work on the oven, be careful
when handling t he sheet met al part s.
T here are sharp edges present and you
can cut yourself if you are not careful.
Refer to Figure 15 on the next page for the follow-
ing steps.
1.
Turn off the electrical power to the oven.
2.
O pen the oven door for the component you
wish to remove.
To remove the lower air vent grille,
3.
move the two front oven door latch screws,
(see Figure 14), then pull the posts on the ends
of the air vent grille out of the catches in the
chassis.
To remove the oven light switch,
4.
nect the wires from the terminals, press in on
the locking arms, and push the switch out of
the vent (see inset 1).
PULL TOP OF VENT GRILLE FORWARD
Figure 14
discon-
TO REMOVE POST FROM CATCH
LOWER AIR VENT GRILLE
To remove the oven door latch assem-
5.
bly (see inset 2):
a) Use a 1/4
socket and remove the two front hex-head
screws from the latch bracket.
b) Pull the latch assembly to the right so that
the flange on the left side clears the bracket,
and then pull it forward as far as the wires
will allow.
c) Remove the wires from the switch con-
nectors and the motor wires from the main
harness.
To replace a door lock or door un-
d)
lock switch on the latch assembly,
move the two screws from the switch body,
and remove the switch.
To remove the hi-temp cutout (see in-
6.
re-
set 3):
a) Remove the two 1/4
from the bracket.
b) Remove the hi-temp cutout and discon-
nect the wires.
7.
Install the replacement component.
8.
Reassemble the oven.
PULL TOP OF VENT GRILLE FORWARD
TO REMOVE POST FROM CATCH
OVEN DOOR
LATCH SCREWS
CATCH
OVEN CHASSIS
POST
Page 48
SMW Oven Service Manual
ratchet and a 1/4
thin-wall
"
"
hex-head screws
"
re-
Advertisement
Table of Contents
Troubleshooting
