Removing A Halogen Light Assembly - Thermador CJ302B Service Manual

Lit. No. 94-30-007A

REMOVING A HALOGEN LIGHT ASSEMBLY

WARNING
Turn off the electrical power going to the
oven before servicing.
CAUTION
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
1. Turn off the electrical power going to the
oven.
2. To make servicing inside the oven easier,
remove the microwave oven door (see
Page 37 for the procedure).
3. Remove the oven racks.
4. Remove the screws from the rack support
that is over the halogen light you wish to
service.
CAUTION: When you remove the halogen
lens holder and lens in the next step, be care-
ful that the lens does not fall out and break.
5. Remove the four screws from the halogen
lens holder and remove the holder and
lens from the oven liner.
6. Remove the screws from the metal screen
that is over the halogen light and remove
the screen.
7.
8.
Screw
(1 of 4)
9.
Lens Holder
& Lens
10. Remove 3/8˝ of insulation from the cut
11. Twist two small wire nuts over the ends
Page 29
CJ Oven Service Manual
Pull the light assembly out of the oven
liner cutout and remove the halogen bulb
from the socket.
Cut the leads that are coming from the
light socket near the socket body.
Cut the leads of the new light assembly
approximately 3˝ from the body.
lead ends and the wiring harness.
of the leads.
Screw
(1 of 20)
Metal
Screen
Cut Leads Here
Halogen Bulb
Light
Assembly