https://appliancetechmanuals.com
W arming Drawer Section
To Replace Thermostat or On/Off Switch
A Remove drawer assembly ( See Figure 1.)
Figure 1. REMOVIN G T H E DRAW ER
To remove the drawer:
W A RN I N G: D o not rem ove dr awer
!
while hot.
•
Pull drawer to fully open position.
!
Be sure drawer is empty before removing.
•
Lift up on left side Release Lever and press down on
the right side Release Lever.
•
Firmly pull the drawer outward until each D rawer
Rail pulls free from each Inner Cabinet Slide. Retract
B. Remove drawer front
Figure 2.
Drawer Assembly
Front Frame Brush
Gasket, Door
To replace the drawer:
•
Be sure Cabinet Rails are pushed inside cabinet.
•
Align each D rawer Rail to each Inner Cabinet Slide.
Use the Slide Lock to guide placement.
•
Close the drawer completely; the Slide Lock will se-
cure the drawer.
•
Pull out drawer fully to check that both locks are
engaged.
Page 32
SMW O ven Service Manual
Screws are
hidden behind
gasket
Screw (10)