Removing The Convection Bake Element - Thermador SMW 272 B Service Manual

https://appliancetechmanuals.com
Lower O ven Section
REMOVIN G THE CON VECTION BAKE ELEMEN T
Turn off the electrical power circuit to the
oven at the main junction box before ser-
vicing this unit.
W hen you work on the oven, be careful
when handling t he sheet met al parts.
T here are sharp edges present and you
can cut yourself if you are not careful.
Refer to Figure 10 for the following steps.
1. Turn off the electrical power to the oven.
2. To make servicing easier, remove the oven
door (see Page 57).
WARNING
CAUTION
CONVECTION
ELEMENT
Top
Screw
3. Remove the racks from the oven.
4. Remove the front screws from the left and
right oven rack supports and remove the sup-
ports from the oven liner.
5. Remove the screws from the convection baffle
and remove the baffle from the back of the
oven liner.
6. Remove the screws from the convection bake
element bracket and the screw from the bot-
tom support and pull the element forward,
then disconnect the wires from the terminals.
7. Install the new convection bake element and
connect the wires to the terminals.
8. Reassemble the oven.
BACK OF
LINER
Bracket
Bracket
Screws
Bottom
Support
Support
Screw
Convection Baffle
Bottom Screws
Figure 10
Page 41
SMW Oven Service Manual
CONVECTION FAN
ASSEMBLY NOT SHOWN
Top
Screw