Warming Drawer Section
To Replace Thermostat or On/Off Switch
A Remove drawer assembly ( See Figure 1.)
Figure 1. REMOVING THE DRAWER
To remove the drawer:
WARNING: Do not remove drawer
!
while hot.
•
Pull drawer to fully open position.
!
Be sure drawer is empty before removing.
•
Lift up on left side Release Lever and press down on
the right side Release Lever.
•
Firmly pull the drawer outward until each Drawer
Rail pulls free from each Inner Cabinet Slide. Retract
B. Remove drawer front
Figure 2.
Drawer Assembly
Front Frame Brush
Gasket, Door
To replace the drawer:
•
Be sure Cabinet Rails are pushed inside cabinet.
•
Align each Drawer Rail to each Inner Cabinet Slide.
Use the Slide Lock to guide placement.
•
Close the drawer completely; the Slide Lock will se-
cure the drawer.
•
Pull out drawer fully to check that both locks are
engaged.
Page 32
SMW Oven Service Manual
Screws are
hidden behind
gasket
Screw (10)