Takara Belmont INOVA-EX Installation Instruction

INOVA-EX
This installation instruction is an annex of the operation manual. However, this instruction contains important
information. Please keep this installation instruction in a safe place for your future reference as well as the
operation manual.
Installation Procedure
1
Carry the chair to the predetermined position.
Hold the pallet when carrying.
(If holding the upper part only, the base may drop
off. This may cause injury.)
2
Apply a rabber ring to the base.
After the chair is placed on the installation position, apply a rubber ring to the rim of the base with lifting
the base from the floor.
3
Connect the equipment to the power supply.
Use an outlet of AC 230V CE (12A or higher).
(220V/230V/240V (7A or higher), 110V/120V (12A or higher))
Installation Instruction
Bang!
Warning
Rubber Ring
Base
1
After removed from the pallet, the chair must
be lifted up from the floor with holding the iron
Plate below the foot switch and then carried with
holding the base.
Foot switches
Do not lift the front portion of the
seat, the seat portion will break and
it may cause bodily harm or property
damage.
Lifting one side and next the
other side of the chair will
ease the operation.
AC 230V CE (12A or higher) Product
[AB-IVF* B7GE2]
Be sure to connect the earth.
This will prevent electric shock and protect the
electric circuits. If you fail to connect the earth, we
will not assume responsibility to any accident due
to electric leakage.
Base
2021-05
BOOK No. 1E02NHCE