Page 1
This product is an industrial shampoo unit designed for barbers and hair salons. Only use this product for its intended purpose and do not use it for non-hairdressing work. Keep this instruction and refer back to them when required. For installation and assembly of this product, contact your local Takara Belmont dealer. 2021.05 Version 2 No.1E07Q7A0...
Table of Contents Introduction Description of Warning Symbols ....................Safety Precautions .......................... Precautions for Use ........................Name of Parts ..........................Preparation Remove the cover ..........................Sponge Installation ......................... Installation of the Cover ......................... How to Use Using the Shower Head ........................To Fill up the Basin with Water .....................
Description of Warning Symbols ■ Before using this product The "Safety Precautions" and "Precautions for Use" contained in this booklet should be thoroughly read and understood before use. ■Precautions listed here The precautions listed here are to ensure that this product can be used safely, and to prevent any danger or risk to the person using this product or those around them.
Precautions for Use ●Do not leave the shower head immersed in water. If pressure in the water pipes decreases due to repairs that follow water stoppages, the water in the basin may flow back through the shower head. ●Do not wet the shower head holder with water. Failure to follow this instruction may cause water leaks.
Remove the Cover 1 Turn the cover counterclockwise. Turn the cover around 5 degrees. Cover 2 Pinch the front and back of the cover to deform and remove the catch. 【Image】 Catch Do not remove the cover of holder forcibly. Caution Failure to follow the instruction may cause damage the product.
Using the Shower Head Spa-shower head Spa-shower head Changing the selection switch position switches between Shower Mode and air Low-splash Mode. <Shower Mode> <Low-splash Mode> Selection switch Protrusion Press the switch on the Press the switch on the side with the protrusion. flat side.
To Fill up the Basin with Water To fill the basin with water, rotate the drain cap in <Filling the basin> the clockwise direction to close the drain outlet. The amount of water should be below the level shown by the dotted line in the illustration below (just below the shower hose slot).
Maintenance Conduct the after-use care and always keep this product clean for later use. Leaving dirt uncleaned may cause them to get moldy or smell. - Turn off the power switch and pull off the power plug when conducting maintenance. There is a risk of electrical shock or ignition.
Page 9
Maintenance Sponge Cover Sponge is consumable supply. Replace the sponge if degradation causes rubbing sound when the hose is moving. (Available at additional cost) Sponge Remove the cover from the holder. [Page 5] - Remove the sponge from the hose and wash with water. Sponge holder - After washing the sponge with water, squeeze it like pressing with both hands.
Before Requesting Repairs If the following problems occur, check the product before asking for repairs. Symptom Check this Solution The cover has come off. Attach the cover. [Page 5] Replace the cover if it easily comes off repeatedly when the hose is moving. When the hose is moved, it makes The sponge is protruding from the end If there is sound even though the sponge is in...
Page 12
TAKARA BELMONT CORPORATION 1-1, 2-Chome, Higashi-shinsaibashi,Chuo-ku,Osaka,Japan TEL : +81-6-6213-5945 FAX : +81-6-6212-3680 Printed in Japan...
Need help?
Do you have a question about the EX-ESYMZ and is the answer not in the manual?
Questions and answers