Step 16: Bluetooth Connection Check; Description - Beko Arcelik BLG15 C7S Service Manual

Hide thumbs

Table of Contents

BLG15 C7S SERVICE MANUAL

4 for water level sensor details; 7 for FM details

Warnings to be displayed on the 7S:

Refer to the knob position and information table.

Condition to pass to the next step:

a) If there is water level sensor error, "Water Level Sensor Error" will be shown for 3

seconds without water being taken in and the step of "Display of the Errors occurred

in Service Mode" which is the last step of "Service" mode is started.

b) If there is not Water Level Sensor Error, but there is NTC error; "NTC Error" is

displayed until water is taken in up to 'Psafety - 20.0 Hz' frequency level, heater will

not be activated and "Start/Pause" button needs to be pressed in order to pass to the

next step. Unless the water level is completed, next step will not be started even if

the "Start/Pause" button is pressed.

c) If none of the above errors is available (if everything is normal), after water intake

is completed and "Water Heater" is displayed in the text line, next step will be taken

in 2 ways:

i) If the "Start/Pause" button is pressed;

ii) When the temperature of the water rises above +5 C

after the water intake is completed and the heater is activated immediately.

Timeout: If "Start/Pause" button is not pressed within 2*3 = 6 minutes, it goes into

"OFF" mode.

Switching to next step:

Press the "Start/Pause" button.

(if there is not any error and water intake is completed)

NOTE: If you turn the knob to Off position, the machine will switch to "OFF" mode.