Service Function Test; Step 1: Switching To The Service Programme - Beko Arcelik BLG15 C7S Service Manual

BLG15 C7S SERVICE MANUAL

4 SERVICE FUNCTION TEST

WARNING 1: If you encounter a safety problem during the test, go to the step
"Display of the Errors Occurred in the Service Mode" no 16.
Warning 2 : If there is an active safety error on the washing machine while checking
on test mode the error code will be shown on the screen. In such a case it will not be
possible to turn off the washing machine using the program selection knob. In order
to fix the error it is required to cut the supply of the washing machine by unplugging.

Step 1: Switching to the service programme

Description:
While the machine is in "OFF" position, it is switched on by turning the knob to "ON"
while the "temperature setting" key is pressed.
If child lock is active before the machine is switched off, it should be disabled when
switched on.
Warnings to be displayed on the 7S:
Refer to the knob position and information table
Condition to pass to the next step:
1) The door should be locked;
2) Motor, motor board and other components should be energized over the door lock;
3) Energy is supplied over the door lock, and then process of sending the motor
parameters to the motor board is completed (approx. 7-8 secs) and then if
"start/pause" button is pressed, the next step will be started.
If the "start/pause" button is pressed before this 7-8 second synchronization process
(sending the motor parameters) is not completed, "Door is being locked" will be
written in the 2nd text line. When the sending process of motor parameters is
completed, the next step is started automatically.
Timeout: If "Start/Pause" button is not pressed within 2*3 = 6 minutes, it goes into
"OFF" mode.
Switching to next step:
Step 2 is automatically initiated when door is locked and motor communication is
provided.
For independent controls:
Knob cannot be turned in this stage.
Sensitivity: Public