Detergent Box Installation/Removal
6.10
6.10.1 Removal
Detergent box is put in its place in the body prior to front wall installation; connections
of inlet hoses such as the drum inlet hose, valve connection and steam generator hose
assembly are established. No screw of the detergent box is installed; the detergent
box assembly will be held in place by the drum inlet hose, and the detergent box snap
located on the upper part of the side body.
Picture 6.78
Picture 6.80 Detergent box removal
Picture 6.81
Sensitivity: Public
Picture 6.79
After the panel assembly is installed,
detergent box is pushed frontwards and
contacted with the gasket on the front
surface panel assembly.
Installation is completed by
tightening the 3 screws on the
panel assembly and 1 screw on
the side toeboard of the body as
shown in Pictures 6.80 and
6.81.
BLG15 C7S SERVICE MANUAL