Electrical Connection - Beko WTIK94121F User Manual

Adjustment of the Feet:
• When you turn the rotary knob shown in-
side the circle in the direction of the ar-
row, the machine will raise 0.3 mm up. If
you turn it in the opposite direction of the
arrow, the machine will lower by 0.3 mm.
• You can use the water meter to check the
rear and front feet of the machine for the
proper setting.
• Do not adjust the rear feet using re-
chargeable devices. Use a screwdriver in-
stead.
Adjusting the Feet with the Water Level
Indicator:
• To adjust the Water Level Indicator, you
must remove the Detergent Drawer.
• The bubble inside the Water Level Indic-
ator must be in the middle for the sys-
tem to work correctly.
• If the bubble inside the Water Level Indic-
ator is on the left, the right preset foot of
the Washing Machine must be adjusted.
• If the bubble inside the Water Level Indic-
ator is on the right, the left preset foot of
the Washing Machine must be adjusted.
• If the bubble inside the Water Level Indic-
ator is on the rear, the front preset foot
of the Washing Machine should be
turned left (clockwise).
• If the bubble inside the Water Level Indic-
ator is on the front, the front preset foot
of the Washing Machine should be
turned right (counterclockwise).

4.7 Electrical Connection

Connect the product to a grounded outlet
protected by a 13 A fuse. Our company
shall not be responsible for the damages
that shall be incurred due to using the
product without grounding according to
local regulations.
• Connection must comply with national
regulations.
• The electrical connection cable infra-
structure of the product must be ad-
equate and suitable for product require-
ments. It is recommended to use a
Ground Fault Circuit Breaker (GFCI).
• Power cable plug must be within easy
reach after installation.
• If the current supply to the fuse or
breaker in the house is less than 13
Amps, have a qualified electrician install
a 13 amp supply.
• The voltage specified in the "Technical
specifications" section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs. Overheating and
burning may occur due to the connecting
cable.
Damaged power cables should be
replaced by the authorised service
in order to prevent possible danger.
Important
Fitting a different plug:
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals on your plug, proceed as follows:
EN / 15