Step 17: Pump Check; Description; Step 18: Display Of The Errors Occurred In The Service Mode - Beko Arcelik BLG15 C7S Service Manual

BLG15 C7S SERVICE MANUAL
NOTE: If you turn the knob to Off position, the machine will switch to "OFF" mode.

Step 17: Pump check

Description:

The motor which runs at 52rpm in the previous step will be stopped.
Pump is operated.
Warnings to be displayed on the 7S:
Refer to the knob position and information table.
Condition to pass to the next step:
You can pass to the next step two only in one way:
1) If the water level in the machine decreases to "Psafety - 15.0Hz" level, the next
step is started automatically.
Unless the water level reaches to "Psafety - 15.0Hz"
check of "Jet Pump" will not started even if "Start/Standby" button is pressed.
2) If "Start/Pause" button is pressed.
Timeout: If "Start/Pause" button is not pressed within 2*3 = 6 minutes, it goes into
"OFF" mode.
Switching to next step:
1) Step is changed automatically with the level check.
Unless the water level reaches "Psafety - 15.0Hz",
check of the "Jet Pump" will not started even if the "Start/Pause" button is pressed.
2) If "Start/Pause" button is pressed.
NOTE: If you turn the knob to Off position, the machine will switch to "OFF" mode.

Step 18: Display of the Errors occurred in the Service Mode

Description:
All components are off.
Condition to pass to the next step:
If the Bluetooth connection has been established as defined, this step will be passed
automatically.
If there has been a problem in the Bluetooth connection, the machine will not
proceed to the Pump step. Error code will be written
Position to turn the knob to
8,9,10,11,12
Sensitivity: Public