Assembly - Hyundai HDBT52-A Original Instructions Manual

3. ASSEMBLY

HANDLE INSTALLATION
Remove the upper part of the handle attachment (1) by unscrewing the 4 screws. Install the operating handles (3 and
5). The right-hand grip (3) is equipped with engine controls, the trigger of the right-hand grip should be directed toward
the gearbox.
Install the rod assembly to the engine using four screws.
Adjust the comfortable position of the handles and eyelets for the shoulder strap.
Hook the shoulder strap to the eyelet
Assembly of the carter of protection
- Install the carter of the protection on mounting plate; make sure that the holes are aligned.
- Screw the carter of protection with the 2 screws.
NOTE: the carter of protection shall be always installed.
Assembly of the 3-theeth blade (for brushcutting)
Warning - sharp edges; wear gloves when manipulate the blade.
- Insert a metal locking tool in the hole on the side of the drive sprocket and on the drive.
- Remove the retaining nut, the cover bell and the plate.
- Install in the following order, on the shaft: the blade, the plate, the cover bell.
- Screw with the retaining nut.
- Remove the metal locking tool.
To disassemble the blade, insert a metal locking tool in the hole on the side of the drive sprocket and on the drive.