Cisco PenTeleData IP DECT 6825 Series User Manual page 35

Set the Timer to Automatically Lock the Handset
You can set the handset to lock the keypad after a specific length of inactivity. When the keypad locks, you
need to unlock it before you can use it.
Note When the keypad is locked, you can only dial emergency numbers.
Procedure
Step 1 Press Menu
Step 2 Select Settings
Step 3 Highlight your choice.
• Off (default): The keypad never locks.
• 15 seconds: The keypad locks in 15 seconds.
• 30 seconds: The keypad locks in 30 seconds.
• 45 seconds: The keypad locks in 45 seconds.
• 1 minute: The keypad locks in 1 minute.
• 2 minutes: The keypad locks in 2 minutes.
• 3 minutes: The keypad locks in 3 minutes.
• 4 minutes: The keypad locks in 4 minutes.
• 5 minutes: The keypad locks in 5 minutes.
Step 4 Press Select to save the setting.
Change the Settings PIN
You can set the handset to require a PIN before the handset can reset to the default settings.
The default PIN is 0000.
Procedure
Step 1 Press Menu
Step 2 Select Settings
Step 3 Enter the current PIN and press OK.
Step 4 Enter a new PIN and press OK.
You must use four digits for the PIN.
Step 5 Press Select to save the setting.
Allow the Handset to Ring While Charging
If you don't want the handset to ring while it is charging, you can turn off the ringer. Incoming calls continue
to display on the screen.
Procedure
Step 1 Press Menu
Step 2 Select Settings
Step 3 Highlight your choice.
• Off (default): The handset will ring while on the charger.
• Silent: The handset won't ring will on the charger.
Step 4 Press Select to save the setting.
35 | P a g e
.
> Security > Automatic keylock.
.
> Security > Change PIN.
.
> Silent charging.
Cisco IP DECT 6825 Series User Guide