Cisco PenTeleData IP DECT 6825 Series User Manual page 21

Put a Call on Hold
Procedure
Step 1 From an active call, press Hold.
Step 2 Press Resume to pick the call back up.
Swap Between Active and Held Calls
When you have an active call and a held call, you can easily swap the calls. The current active calls goes on
hold and the previously held call becomes the active call.
Procedure
Press Swap.
Retrieve a Call on Hold with Call Park
You can pick up a parked call from anywhere in your network.
Before you begin
You need the number that was used to park the call.
Procedure
Step 1 Dial *66 + the parking spot the call was placed in and press Answer/Send
Step 2 You are now connected with the caller in that parking slot #.
Forward Calls
You can forward incoming calls from your phone to another number.
Enable Call Forward – All Calls
Procedure
Step 1 Lift the receiver and listen for dial tone.
Step 2 Press *72 or Forward softkey.
Step 3 When prompted, enter your PIN.
Step 4 Press 1.
Step 5 When prompted, enter the destination phone number, starting with a 1, i.e. 1 800 555 1212.
Disable Call Forward – All Calls
Procedure
Step 1 Lift the receiver and listen for dial tone.
Step 2 Press *72 or Forward softkey.
Step 3 When prompted, enter your PIN.
Step 4 Press 2.
21 | P a g e
Cisco IP DECT 6825 Series User Guide
.