Auto-Sense Mode (1100 Only); Scanner Time-Out; Delay Between Re-Read - CipherLab SmartScan Manual

Scanner Configuration
Serial Command
0068
Serial Command
0070
Serial Command
0072

2.4 AUTO-SENSE MODE (1100 ONLY)

Serial Command
0333

2.5 SCANNER TIME-OUT

1) Read this label to specify the time interval before the scan engine times out in Laser, Auto Off, or
Auto Power Off mode.
2) Read the "Decimal
automatically shut down after being idle for 10 seconds.
3) Read the "Validate" label on the same page to complete this setting.
Serial Command
0207

2.6 DELAY BETWEEN RE-READ

Serial Command
0336
10
SmartScan Manual
Auto Power Off Mode
Momentary Mode
<Laser Mode>
(Default for
1100/1105/1166/1200/1266)
Enable
Value" label on page 57. For example, read "1" and "0" for the scanner to
100 ms
Serial Command
0069
Serial Command
0071
Serial Command
0073
Serial Command
0332
Serial Command
0337
Enter Setup
Alternate Mode
Repeat Mode
Test Mode
<Disable>
Scanner Time-Out
after ... seconds
200 ms