How To Upgrade 3666 Firmware; Find Out Firmware Version Of 3666 - CipherLab SmartScan Manual

HOW TO UPGRADE 3666 FIRMWARE

1) Connect the power supply cord from the 3666 cradle to a proper power outlet.
2) Connect the serial cable between the 3666 cradle and your computer via the RS-232 port.
3) Refer to section 1.5 for a scanner to set connection with the 3666 cradle.
Read the "Set Connection" label first, and then the "Serial Number" label within 5 seconds.
Both labels can be located at the bottom of the cradle.
4) Read the following labels in sequence for the 3666 cradle to enter the download mode.
The LED of the cradle will be flashing red and green to indicate it is ready for downloading.
5) Run the download utility "ProgLoad.exe" or "Download.exe" on your computer.
(Download.exe requires version 2.3 or later!)
Open the firmware update "3666*.shx", and select the correct COM port.
Baud rate
Data bit
Parity
Flow control
6) The 3666 cradle will automatically restart itself when upgrading firmware is completed
successfully.
7) Read the "Update" label for the scanner to resume its operation (exit the configuration mode).

FIND OUT FIRMWARE VERSION OF 3666

1) Connect the power supply cord from the 3666 cradle to a proper power outlet.
2) Connect the serial cable between the 3666 cradle and your computer via the RS-232 port.
3) Refer to section 1.5 for a scanner to set connection with the 3666 cradle.
Read the "Set Connection" label first, and then the "Serial Number" label within 5 seconds.
Both labels can be located at the bottom of the cradle.
Enter Setup
3666 Download
– 38,400 bps
– 8
– None
– None
Update
Appendix IV Upgrading Firmware
65