Upgrading Firmware; How To Upgrade 1166/1266 Firmware; Using 3666 - CipherLab SmartScan Manual

UPGRADING FIRMWARE

HOW TO UPGRADE 1166/1266 FIRMWARE

You can only upgrade firmware of one scanner at a time. You must remove the battery of each of
the rest scanners when there is more than one scanner connected to your computer, either via (1)
the 3666 cradle or (2) the 3667 cradle or any generic Bluetooth dongle.
Note: In case it fails downloading due to low battery, make sure the targe scanner is loaded with a
fully charged battery.

USING 3666

1) Connect the power supply cord from the 3666 cradle to a proper power outlet.
2) Connect the serial cable between the 3666 cradle and your computer via the RS-232 port.
3) Refer to section 1.5 for the target scanner to set connection with the 3666 cradle.
Read the "Set Connection" label first, and then the "Serial Number" label within 5 seconds.
Both labels can be located at the bottom of the cradle.
4) Read the following labels in sequence to configure the scanner to use RS-232 as output interface.
5) Read the following labels in sequence for the scanner to enter the download mode.
The scanner will respond with beeps to indicate it is ready for downloading.
Enter Setup
Activate RS-232 Interface
115200 bps
Update
Appendix IV
63