Using 3667 Or Generic Dongle - CipherLab SmartScan Manual

Scanner Configuration
6) Run the download utility "ProLoad.exe" or "Download.exe" on your computer.
(Download.exe requires version 2.3 or later!)
Open the firmware update "1x66-xx.shx", and select the correct COM port.
Baud rate
Data bit
Parity
Flow control
7) The scanner will automatically restart itself when upgrading firmware is completed successfully.

USING 3667 OR GENERIC DONGLE

1) Connect the 3667 cradle or any Bluetooth dongle to your computer via the USB port.
2) Refer to section 1.6.1 for the target scanner to establish a connection with your computer via
the 3667 cradle or a dongle.
Read the following labels in sequence to configure the scanner to use Bluetooth Serial Port as
output interface.
3) Same as steps 5 ~ 7 above.
64
SmartScan Manual
Enter Setup
Download
– 115,200 bps
– 8
– None
– None
Enter Setup
Activate Bluetooth SPP (and read labels for PIN code...)
Update