Code 25 Parameters; Industrial 25 - CipherLab SmartScan Manual

Scanner Configuration

4.3 CODE 25 PARAMETERS

4.3.1 INDUSTRIAL 25

Serial Command
0080
START / STOP PATTERN SELECTION
Serial Command
0130
Serial Command
0132
CHECKSUM VERIFICATION
Serial Command
0139
CHECKSUM TRANSMISSION
Serial Command
0141
CODE LENGTH QUALIFICATION
1) Read the label to enable either Max. /Min. length qualification or fixed length qualification.
2) Read the labels for Max. /Min or fixed length separately.
3) Read the "Decimal
4) Read the "Validate" label on the same page to complete this setting.
Serial Command
0208
26
SmartScan Manual
<Enable>
<Industrial 25>
Matrix 25
Enable
<Enable>
Value" label on page 57 for the desired inter-character delay (millisecond).
Enable Max./Min. Length ...
Serial Command
0081
Serial Command
0131
Serial Command
0140
Serial Command
0142
Enter Setup
Disable
Interleaved 25
<Disable>
Disable