Advertisement
Rail Section 4:
Step 1: Start by attaching Rail D (75 cm) to the inside Rail Clip of Splitter-B facing the front of the Base. Connect through Arm
M-7, F-6, and D-8. Repeat for second rail.
The end of this section drops the Marble onto the See-Saw section. If you have not already attach the See-Saw arms.
The last See-Saw arm will drop the Marble on the exit section that uses Rail C (36 cm) and starts at Arm B-1 and passes
through Arm D-2 entering the left facing rail clip on the bottom Elevator Ring. Repeat for second rail.
SEE-SAW ARM
(QTY: 4 LEFT & 3 RIGHT)
Attach Arm Holder B to the square receiver side of
Arm Sheath to create the arm.
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Splitter B
Cut two 55mm lengths
of rail and insert into
See-Saw as shown
using a Rail Clip to
support the ends of
the rail.
Attach the arm to the shaft and
the shaft to the base prior to
attaching the round receiver
side of the Arm Sheath to the
See-Saw Arm.
Step1:
Page 15
Advertisement
