Advertisement
Rail Section 3:
Step1: Starting at the top Elevator Ring connect Rail-B
(27 cm) to Rail Clip at the back. Keeping Rail tight connect
through Arm H-6 and attach the Rail to the Rail Clip on single
side of the Rail Splitter C. Repeat for second rail.
Step2: Start by attaching Rail H (480 cm) to the inside Rail Clip
of Splitter-C facing the front of the Base. Keeping Rail tight
connect through Arm L-7. Next start a vertical nested loop
where each successive loop is slightly smaller than the one
before it beginning with Arm O-11. Continue with Arms P-8,
N-8, O-9, P-7, N-7, O-8, P-6, N-6, O-7, P-5, N-5, O-6, P-4, N-4,
O-4, P-3, N-3, O-3, P-2, and exit loop to Arm N-1. Continue to
exit through Arms L-1, H-1, D-1, A-1, and G-1. Finish at Rail
Clip on Elevator Ring 1 at the back of the elevator. Repeat
step for second rail.
Page 14
Splitter C
This top view of the nested loop section shows how each successive loop is
slightly smaller than the one above it. Start with a loop of about 20 cm and
work down to about 17 cm on the bottom loop. These numbers are intended
to be a guide only. Test your loops with the Marble. Adjust until you get good
consistent speed throughout this section.
NOTE:
If length of rail is longer or shorter than
expected try adjusting the size of the nested
loops to better utilize the rails.
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Step1:
Step2:
Advertisement
