Advertisement
B
INSTALLING RAIL
Rail Section 1 & 2:
Step1: Install one side of a rail at a time. Starting at the
top Elevator Ring on the Left side Rail Clip connect Rail-E
(100 cm). Keeping Rail tight connect through Arm D-9, B-7,
A-4, C-4, G-4, and H-4. Next attach the Rail to the Rail Clip
on single side of the Rail Splitter B. Repeat this step for the
second rail.
Step2: Starting at the top Right Elevator Ring Rail Clip
connect Rail-A (15 cm). Next attach the Rail to the Rail Clip
on single side of the Rail Splitter A. Repeat for second rail.
Step 3: Attach Rail F (341 cm) to the inside Rail Clip of
Splitter-A facing the front of the Base. Keeping Rail tight
connect through Arm M-8 and down to Arm R-1. Next start
a nested loop where each successive loop is slightly smaller
than the one before it. Continue with the inside rail connect
Arms W-6, V-6, W-5, V-5, W-4, V-4, W-3, V-3, W-2, V-2, W-1,
and V-1. Exit loop to Arm S-1 and continue around coaster
to Arms T-1, R-1, O-2, M-2, and finish at Rail Clip on Elevator
Ring 2 on the right side. Repeat step for second rail.
Fine Tune: Once each Rail Section is completed run a
marble down your course and make sure ball travels well.
Make any adjustments as needed. Do not worry about
adjusting splitter until all Rails have been connected.
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Splitter B
Splitter A
Step1:
Step2:
Step3:
NOTE:
Start with a loop of about 10 cm on the front and work
down to about 6 cm on the back loop. These numbers
are intended to be a guide only. Test your loops with
the Marble. Adjust until you get good consistent speed
throughout this section.
Page 13
Advertisement
