Table of Contents
Advertisement
Installing the Adapter
Verifying the Installation
Note – Refer to your system installation or service manual for detailed
instructions for the following tasks.
1. Power off your system, using the standard shut down procedures
described in Solaris 2.x Handbook for SMCC Peripherals.
The Solaris 2.x Handbook for SMCC Peripherals is shipped with the Solaris
operating environment software and is available in the on-line
AnswerBook™ documentation.
2. If you are replacing an SBus card with the Sun Quad FastEthernet SBus
Adapter, remove the old card now.
3. Install the Sun Quad FastEthernet SBus Adapter in the selected SBus slot.
4. Connect Ethernet cables to the Sun Quad FastEthernet SBus Adapter and
to an Ethernet network.
After you have installed the Sun Quad FastEthernet SBus Adapter, but before
you boot your system, perform the following tasks to verify the installation.
Refer to the Solaris 2.x Handbook for SMCC Peripherals manual or your Solaris
documentation for the detailed instructions.
1. Power on the system, and when the banner appears, press the Stop-A keys
to interrupt the boot process and to get to the ok prompt.
Installing the Adapter
2
7
Advertisement
Table of Contents
Need help?
Do you have a question about the Quad FastEthernet and is the answer not in the manual?
Questions and answers