Table of Contents
Advertisement
B
Running Diagnostics Tests
This appendix describes how to test the Sun Quad FastEthernet SBus Adapter
by creating a .usertest file for the SunDiag™ system exerciser. There is also
a section describing how to test the adapter with its FCode PROM selftest.
Note – To test the Sun Quad FastEthernet SBus Adapter on systems running
the Solaris 2.5, 2.5.1, or 2.5.1 Hardware: 4/97 operating environments, refer to
the SunVTS User's Guide that shipped with your operating system. The
SunVTS™ nettest diagnostic test automatically probes the network for hme
devices, so creating a .usertest file is not needed.
Using the SunDiag System Exerciser
The SunDiag system exerciser is an on-line diagnostic application that runs
hardware tests. It is used primarily with the OpenWindows software interface
to enable you to quickly and easily set test parameters while running tests.
Note – The SunDiag software does not probe for Sun Quad FastEthernet SBus
Adapter devices by default. For the software to acknowledge an hme<num>
channel, the .usertest file must be edited (described in "Editing the
.usertest File" on page 38) before bringing up the SunDiag exerciser.
37
Advertisement
Table of Contents
Need help?
Do you have a question about the Quad FastEthernet and is the answer not in the manual?
Questions and answers