Disassembling Procedure - Sharp AH-X079E Service Manual

AH-X079E/X099E
AY-X079E/X099E
FOR INDOOR UNIT MODEL AH-X079E/X099E AND AY-X079E/X099E
CAUTION: DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE ANY SERVICING
1. Using the narrow slotted screwdriver or similar, remove
the screw cover from the front panel.
How to remove the screw cover
a. Press the top of the screw cover with the flat-tipped
screwdriver (or nail, etc).
b. Insert the flat-tipped screwdriver (or nail, etc) into
the lower clearance, and pull and lift it toward you
for removal.
a
b
2. Remove two screws from the front panel.

DISASSEMBLING PROCEDURE

Screw cover
3. Open the open panel, and remove the right air filter.
4. Remove one inner screw.
Note: During reassembly, don't tighten the screw
strongly, or it will become idle.
5. Remove the fastening screw which retains the cable,
and remove the cord.
Note: During reassembly, install the holder after
installing the front panel. This will make it
easier to assemble the front panel.
30