Sharp AH-X079E Service Manual page 37

6. Disconnect the connector. (3 places)
Disconnect the Faston terminal. (9 places)
Remove the 3 screws of the control PWB, and the
control circuit will be ready for removal from the control
box.
7. Remove 2 fastening screws of the control box.
Remove small screw which fasten the ground cable.
8. Remove the outdoor fan.
9. Remove 2 screws which fasten the motor angle.
Pull up the motor angle for removal.
(During reassembling, treat the lead wire to prevent it
from being in contact with the propeller fan.)
10. Remove 3 motor fastening screws, and remove the
motor.
11. Remove the bulk head.
Remove 2 fastening screws. Lifting the bulk head,
remove 2 inner hooks.
LX-BZA175JBE0
12. Remove 2 screws which fasten the choke coil on the
bulkhead, and remove the choke coil.
Choke coil
37
AH-X079E/X099E
AY-X079E/X099E
Bulkhead