Lexmark C4342 User Manual page 82

Use printer menus
Menu item
Supply Usage And Counters
Reset Maintenance Counter
Supply Usage And Counters
Tiered Coverage Ranges
Printer Emulations
PPDS Emulation
Off*
On
Printer Emulations
PS Emulation
Off
On*
Printer Emulations
Enable Formsmerge
Off*
On
Printer Emulations
Enable Prescribe
Off*
On
Printer Emulations
Emulator Security
Page Timeout (60 minutes*)
Reset Emulator After Job (Off*)
Disable Printer Message Access (On*)
Print Configuration
Black Only Mode
Off*
On
Print Configuration
Color Trapping
Off
1
2*
3
4
5
Print Configuration
Font Sharpening
0–150 (24*)
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Reset the counter after installing a new fuser.
Adjust the amount of color coverage for each printing range.
Set the printer to recognize and use the PPDS data stream.
Set the printer to recognize and use the PS data stream.
Activate Formsmerge to store the forms into the hard disk or
Intelligent Storage Drive (ISD).
Note: A hard disk or an ISD must be installed.
Enable Prescribe emulation.
Configure the security settings of the printer during emulation
mode.
Set the printer to print always color content in grayscale .
Enhance the printed output to compensate for misregistration
in the printer.
Set a text point-size value below which the high‑frequency
screens are used when printing font data.
For example, if the value is 24, then all fonts sized 24 points or
less use the high‑frequency screens.
82