Advertisement
Quick Links
Advertisement
Related Manuals for Durabook Z14I
Summary of Contents for Durabook Z14I
- Page 1 P/N: 62+009698+00 © 2021 Twinhead International Corp and/or its affiliates. All rights reserved.
-
Page 2: Package Contents
Z14I Discrete VGA Expansion Chassis Package Contents If any of following items is damaged, please contact your retailer. Adapter Power code Expansion chassis with Bottom cover with PCIe Expansion brackets (2) Rubber gasket cables Screw Type Screw Name Quantity ISOT-M3.0X10L 6 (bumpers) ISOT-M3.0X7L... -
Page 3: Installation
This section will guide you on how to install the discrete VGA expansion chassis to your notebook. NOTE • For Z14I laptop equipped with discrete NVIDIA graphic MXM expansion box, a 120W power adapter must be use. Installing the Discrete VGA... - Page 4 Z14I Discrete VGA Expansion Chassis 2. Remove the bumpers. 3. Pry to remove the mylar from the lower case. 4. By aligning with the screw holes, install the expansion brackets onto their respective slots. NOTE • Ensure that the 4 O-rings ( ) are properly embedded on the upper part of the screw holes (C).
- Page 5 Z14I Discrete VGA Expansion Chassis 5. Attach the 4 screws (ISOT-M2.6X4L) to secure the expansion brackets to the lower case. 6. Place the expansion chassis on the top of the lower case. Ensure that the screw holes are properly aligned.
- Page 6 Z14I Discrete VGA Expansion Chassis and then fasten the 4 screws to secure the expansion brackets. 7. Attach the 4 screws (ISOT-M2.6X3L) first to secure the expansion chassis to the lower case. Then continue to attach the remaining 6 screws (ISOT-M2.6X8L).
- Page 7 Z14I Discrete VGA Expansion Chassis 8. With the protruding tabs facing down, install the rubber gasket onto its compartment. Press down each tabs to ensure that the gasket is properly seated in place. CAUTION! To ensure the correct placement and orientation, please observe the printed direction (G) when installing the rubber gasket.
- Page 8 Z14I Discrete VGA Expansion Chassis 10. Place the bottom cover onto the chassis. 11. Attach the 14 screws (ISOT-M2.6X4L) to secure the bottom cover.
- Page 9 Z14I Discrete VGA Expansion Chassis Discrete VGA Expansion Chassis Screws Screw Type Screw Name Quantity Torque ISOT-M3.0X10L 6 (bumpers) 2.5 ± 0.3 Kgf-cm ISOT-M3.0X7L 8 (bumpers) 2.5 ± 0.3 Kgf-cm 4 (expansion ISOT-M2.6X3L 2.5 ± 0.3 Kgf-cm chassis) ISOT-M2.6X8L 6 (expansion 2.5 ±...
Need help?
Do you have a question about the Z14I and is the answer not in the manual?
Questions and answers