Section Two: Operation; Display Patterns - Fire-Lite Alarms LCD-40 Manual

Remote fire annunciator for the ms-9200 addressable fire alarm control panel

Hide thumbs Also See for LCD-40:

Table of Contents

Section Two: Operation

The LCD-40 directly displays (mimics) the information on the MS-9200 main circuit

board LCD display with the following exceptions:

• Upon power-up, the LCD-40 may display the following message until a valid message

is received from the MS-9200.

• If an LCD-40 fails to receive communications from the panel for a period of over 30

seconds, it will activate its local sounder (if so programmed) and display the following

message:

• When placing the host MS-9200 into some aspects of the Programming Mode, the

LCD-40 will display the following message:

The message shown above will appear at the Level One passcode for (1) Autoprogram,

(2) Point Edit, (3) System Edit, (4) Passcode Entry and (5) Load. The same message

will also appear at the Level Two passcode for (1) Disable, (2) Clear History and (4)

Time.

Technical Manuals Online! - http://www.tech-man.com

Document 50327

Rev B

firealarmresources.com

3/16/96

P/N 50327:B

Table of Contents