Table of Contents
Advertisement
8.0 FIREPLACE SET UP
8.1 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
8.1.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1.
Remove safety barrier.
2.
Remove the valve access cover.
3.
Using a phillips head screwdriver, remove screws securing valve
access cover (1 ea. side).
4.
Locate (2) spring loaded handles at bottom of firebox. Pull
handles out and down to release.
5.
Lift glass frame assembly up and off (2) tabs at top of firebox.
8.1.2 Install Glass Frame Assembly
1.
Place glass frame assembly top over tabs at top of firebox.
2.
Pull bottom handles out and up to secure assembly bottom.
3.
Reinstall valve access cover.
4.
Reinstall safety barrier.
GAS VALVE ACCESS COVER
HANDLE LOCATION
FIGURE 8.1 Glass Frame Assembly Removal and Installation
38
#SLA-42S
#SLA-42S
R.10 March 2022
R.10 March 2022
8.2 Light Kit
CAUTION: Disconnect all electrical power from the fireplace before
performing this task.
ATTENTION: If converting to Propane, complete the conversion before
installing any light kit components. Follow instructions provided with
the conversion kit (sold separately).
NOTE: To avoid damage and prolong the life of the halogen bulbs,
never touch with bare hands. Always use a soft cloth when handling.
8.2.1 Install Light Kit
1.
Remove the safety barrier and glass frame assembly.
2.
Remove glass media (if installed).
3.
Remove (10) screws securing media tray cover. Lift cover out
of firebox.
4.
Install (6) halogen bulbs (included in component packet) into
lamp bases.
5.
Reinstall the burner cover with (10) screws previously removed.
6.
Reinstall glass media, glass frame assembly, and safety barrier.
HUSSONG MFG. CO., INC.
SECTION 8 FIREPLACE SET UP
Glass Frame Assembly–Light Kit
KOZY HEAT FIREPLACES
Advertisement
Table of Contents
