Maintenance; Troubleshooting; Emergency Operation; Resources Required - Lippert Project 2000 Sliding Step Owner's Manual

Maintenance

1. Make sure unit is parked on a stable, level surface.
2. Make sure power to the unit is turned off and/or disconnected.
Prior to starting maintenance procedures, disconnect power to the step's electrical system to
3. After driving on roads that are salted, wash the step with fresh water.
NOTE: If protective panels need to be removed for service or maintenance, reinstall panels as soon as
possible after service/maintenance has been completed.

Troubleshooting

Resources Required

• Phillips screwdriver

Emergency Operation

1. The sliding electric single step is equipped with a manual activation option.
2. Locate the hole under the step.
3. Using a screwdriver, insert it into the hole (Fig. 1).
4. Push up the driving gear with the screwdriver to disengage the electric motor.
5. Move the step to the desired position.
6. Remove the screwdriver to lower the driving gear and stop the step from moving.
Rev: 02.08.22
prevent inadvertent operation of the step.
Fig. 1
Page 8
CCD-0004560