Installation Steps With The Vehicle Restraint - KIDDY Relax Pro Directions For Use Manual

*
The passenger airbag must be deactivated or another seat
must be used.

6.1.2 Installation steps with the vehicle restraint

Place your kiddy facing the rear on a seat without an active front airbag and
with a 3-point belt (Fig. 15).
Swivel the carry handle (F) to the rear against the vehicle backrest and make
certain that the carry handle buttons (H) lock into place (Fig. 15).
Pull the vehicle restraint out and feed the lap belt through both lap belt
guides (I) and press the safety belt lock tongue with a clearly audible click
into the belt clip (Fig. 16).
Tighten the lap belt (Fig. 16).
Now place the shoulder belt around the baby car seat (A) and feed it through
the diagonal belt guide (L) at the rear of the kiddy seat (Fig. 17).
Make certain that the belt clip is in the correct position. Now pull the belt
system tight.
Make certain that the belt is not twisted (Fig. 18)!
Some vehicles are fitted with so-called retractor locks. With
this the automatic recoiling of the belt can be blocked, which
makes a more secure installation of the kiddy seat possible.
Read your vehicles' owner manual for more information on this feature or ask
your authorised workshop or dealer.
9
ENG