Installation In The Vehicle - KIDDY Isofix Base 2 Instruction Manual

EN

4. Installation in the vehicle

The support leg must be folded out before installation in the vehicle.
Check now whether the Isofix hooks are opened (see point 5. Removal).
Now slide the connectors onto the Isofix anchor fittings and push firmly
against them (fig. 1).
WARNING
The correct engagement/latching will be confirmed
by the Isofix indicator on the left and right connec-
tor (fig. 1). Check by pulling on the platform that
both connectors are securely locked.
As the final step of the installation, the support leg must be adjusted.
Swing the support leg fixing cover backwards (fig. 2, no. 1) and slide
the support foot out until it rests on the vehicle floor and the support
foot indicator shows 'green' (fig. 2, no. 2). Now lift the platform a little,
until the support leg fixing cover snaps forward again and the 'red'
support leg indicator is no longer visible from the fixing cover (fig. 3).
Check that the mechanism is properly locked by trying to slide the
support foot in without moving the support leg fixing cover. If the sup-
port foot does not move, it is correctly locked in place.
You must always use the Isofix platform with the support leg folded
out and the support foot correctly adjusted!
Now you can install your Kiddy child seat according to its instructions
on your Isofix platform. Check that all systems are properly locked or
adjusted before each trip.
7