Cannot Enable Smdi Link - Northern Telecom DMS-100 Series Manual

6-8 Telephony interface node

Cannot enable SMDI link

If you cannot enable an SMDI link, use procedure 6-5.
Procedure 6-5xxx

Cannot enable SMDI link

Step
1
2
3
4
5
297-7001-503 Standard 02.02 March 1994
Action and response
Disable the SMDI link
From the SMDI Link Status screen, disable the SMDI link.
If the SMDI link is successfully disabled, go to the next step.
If the SMDI link does not disable, go to the procedure called Cannot
disable SMDI link in this chapter and then return to this procedure
and go to the next step.
Enable the SMDI link
From the SMDI Link Status screen, enable the SMDI link.
If the SMDI link is successfully enabled, go to the next step.
If the SMDI link does not enable, check the datafill for the SMDI link
by referring to the DMS VoiceMail Translations Guide,
297-7001-310 , and then go to the next step.
Disable the node
From the Node Status screen, disable the TIFN that is associated
with the SMDI link.
If the TIFN is successfully disabled, go to the next step.
If the TIFN does not disable, go to the procedure called Cannot
disable node in this chapter.
Run the out-of-service diagnostics
From the Card Status screen, run the out-of-service diagnostics for
the 68K card of the TIFN.
If the diagnostics pass, go to the next step.
If the diagnostics fail, go to the procedure called Out-of-service
diagnostics on 68K card fail in this chapter and return to this
procedure once the diagnostics have passed.
Enable the node
From the Node Status screen, enable the TIFN.
If the TIFN is successfully enabled, you have completed this
procedure.
If the node does not enable, go to the procedure called Node
recovery in this chapter.