Channel Stuck In Pending State - Northern Telecom DMS-100 Series Manual

6-14 Telephony interface node

Channel stuck in pending state

If a T1 channel is stuck in the pending state, use procedure 6-14.
Procedure 6-14xxx

Channel stuck in pending state

Step
1
2
297-7001-503 Standard 02.02 March 1994
Action and response
Disable the T1 channel
From the T1 Channel Status screen, disable the T1 channel.
If the T1 channel is successfully disabled, go to the next step.
If the T1 channel does not disable, go to the procedure called Cannot
disable T1 channel in this chapter and then return to this procedure
and go to the next step.
Enable the T1 channel
From the T1 Channel Status screen, enable the T1 channel.
If the T1 channel is successfully enabled, you have completed this
procedure.
If the T1 channel does not enable, go to the procedure called Cannot
enable T1 channel in this chapter.