8. Event
How to Use the Event Function
8.1
Setup Sequence function
The event function can be used to set complex breakpoints or a restart condition. Two kinds of conditions can be
set:
Code: The execution (program counter register) meets a defined address (similar to "usual" breakpoints)
Data: Defined data is written to or read from a defined address
Conditions can be set sequentially.
To use the event function enter debugging mode and choose DebugEvent. The event window will open and
look like this:
FR Family MB2198-01 Emulating and Debugging Installation Guide, Doc. No. 002-05223 Rev. *A
25