Setup; Removing The Machine From The Pallet - Toro Bullseye QuickGroom 710 Operator's Manual

Setup

1
Removing the Machine
from the Pallet
No Parts Required
Procedure
The machine is shipped vertically on the pallet. Use
the following instructions to remove it from the pallet.
DANGER
The attachment is unstable and could swing
when lifted, injuring anyone beneath it or
around it.
• Refer to the lifting machine operator's
manual to ensure that it is rated to lift the
attachment.
• Ensure the lift height is kept to a minimum
and only high enough to remove the
shipping material.
• Do not crawl under the attachment.
1. Place the pallet on level ground.
2. Attach lifting cables to the crossbar and pallet.
3. Lift the attachment and pallet off the ground 50
mm (2 inches).
Important:
Ensure that the lifting cable does
not slide on the pallet.
4. Gently lower the attachment in a controlled way
as shown in Figure 4
5. Remove the upper 3-point hitch pins and
carefully rotate the pallet around the lower
3-point hitch pins.
6. Remove the lower 3-point hitch pins and remove
the pallet.
7. Install the hitch pins.
4
Figure 3
until it is on the ground.
g367141