Inspecting The Machine; Product Overview; Specifications; Attachments/Accessories - Toro Bullseye QuickGroom 710 Operator's Manual

Table of Contents

Advertisement

3

Inspecting the Machine

No Parts Required
Checking the Traction Unit
Requirements
Use the following list as a reference:
Refer to
Specifications (page 6)
horse power and minimum lifting capacity for the
traction unit.
The traction unit must have a category I or II
3-point hitch.
Adequate front-end weight (ballast) to offset the
weight of the machine.
Check the tire air pressure of the traction unit.
Adjust the tire air pressure as needed.
Important:
Do not exceed the maximum
or minimum tire inflation pressures as
recommended by the tire manufacturer.
Checking the Ballast
Requirements
WARNING
Mounting the machine to the rear of the
traction unit decreases the weight on its front
axle. Failure to add required ballast may result
in an accident and severe injury or death.
• To ensure adequate steering control and
stability, you may need to add ballast to
the front of the traction unit.
• Refer to the traction unit operator's manual
for ballast requirements.

Product Overview

Specifications

Specifications and design are subject to change
without notice.
Traction Unit Requirements
Attachment Specifications
for the minimum

Attachments/Accessories

A selection of Bullseye approved attachments and
accessories may be available for use with the machine
to enhance and expand its capabilities. Contact your
Authorized Service Dealer or authorized Bullseye
distributor or go to www.Toro.com/Bullseye for a list of
all approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Bullseye
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Note:
compatible together.
6
Lifting capacity
Minimum output-power rating
Tow system
Width
Length
Height
Maximum transport and
working speed
Maximum capacity
Weight
The Wing Kit and Towable Lift Kit are not
500 kg (1,103 lb)
22 Kw (30 hp)
3-point hitch, category 1 or 2
1.8 m (71 inches)
77.5 cm (31 inches)
150 cm (59 inches)
12 km/h (7.5 mph)
21,600 m
2
/h (232,500 ft
2
/h)
150 kg (331 lb)

Advertisement

Table of Contents
loading

This manual is also suitable for:

46405aa46405ba

Table of Contents