Removing The Attachment - Toro Bullseye QuickGroom 710 Operator's Manual

Removing the Attachment

1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key from the traction unit.
2. Lower the 4 storage legs.
1. Lynch pin
3. Lower the attachment to the ground.
4. Secure the attachment from movement.
5. Loosen the upper link jam nut and rotate the
upper link.
Figure 12
1. Upper link
2. Jam nut
6. Remove the upper link.
7. Remove the lower link arms.
Figure 11
2. Storage leg
3. Hairpin cotter
4. Link pin
Important:
not slide off the traction unit and cannot roll
away.
1. Lower link arm (2)
g346767
8. Start the traction unit and drive it away from the
attachment.
9. Install the hitch pins to the attachment and
secure them with the hairpin cotters.
g345396
1. Hairpin cotter (3)
Important:
When storing the attachment, do
not allow the brush to touch the ground or other
objects to avoid bending the bristles.
11
Ensure that the attachment does
Figure 13
2. Hitch pin and hairpin cotter
(2)
Figure 14
2. Hitch pin (3)
g345394
g345395