Table of Contents
Advertisement
or the edge caves in. Establish a safety area
between the machine and any hazard.
•
Identify hazards at the base of the slope. If
there are hazards, mow the slope with a power
walk-behind mower.
•
If possible, keep the attachment lowered to the
ground while operating on slopes. Raising the
attachment while operating on slopes can cause
the machine to become unstable.
•
Use extreme caution with other attachments.
These can change the stability of the machine and
cause a loss of control. Always keep the machine
in gear when going down slopes. Do not coast
downhill (applicable only to gear-drive units).
Operating the Attachment
Important:
Do not exceed 12 km/h (7.5 mph)
while transporting or operating the attachment.
Figure 10
1.
Raise the attachment and drive to the location
where you will use the attachment and park the
machine on a level surface.
2.
Lower the attachment to the ground.
3.
Engage the parking brake, shut off the engine,
and remove the key from the traction unit.
4.
Adjust the 3-point upper link until the attachment
stands completely flat on the ground.
5.
Drive the traction unit forward.
6.
After operation, raise the attachment and
drive to the next location as needed; refer to
Transporting the Attachment (page
Operating Tips
•
Make very gradual turns. Never make sharp turns
with the attachment.
•
Do not use the attachment if the ground is too wet.
•
Look backward frequently to ensure that the
machine is operating properly, and alignment is
maintained with previous passes.
•
To optimize performance and life of the product,
operate the attachment only when grooming the
intended application area.
•
Make multiple passes over the field either in
the same or in different directions for improved
grooming.
After Operation
After Operation Safety
•
Park the tow vehicle on a level surface; engage
the parking brake of the tow vehicle; shut off the
engine; remove the key; and wait for all movement
to stop before leaving the operator's position.
•
Allow the machine to cool before storing the
machine in any enclosure.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
g340204
•
Replace all worn, damaged, or missing decals.
9).
10
Advertisement
Table of Contents
