Epson RT3B-401SS Safety Manual page 30

Safety Precautions
■ To shut off power to the robot system, disconnect the power plug from
the power source.
■ Before performing any replacement procedure, display a sign (ex.
"Work in progress"), turn OFF the robot system and related equipment,
and then disconnect the power plug from the power source. Performing
any replacement procedure with the power ON is extremely hazardous
and may result in electric shock and/or malfunction of the robot system.
■ Do not connect or disconnect the motor connector while the power is
ON. The manipulator may malfunction which is extremely hazardous.
Also, when you work while the power is ON, it may result in electric
WARNING
shock or malfunction.
■ Be sure to connect the cables with securely protected the high voltage
unit to the Controller properly. Do not allow unnecessary strain on the
cables. (Do not put heavy objects on the cables. Do not bend or pull
the cables forcibly.) It may result in damage to the cables,
disconnection, and/or contact failure. These are extremely hazardous
and may result in electric shock and/or improper function of the robot
system.
■ Carefully use alcohol, liquid gasket, and adhesive following respective
instructions and instructions below. Careless use of alcohol, liquid
gasket, or adhesive may cause a fire and/or safety problem.
Never put alcohol, liquid gasket, or adhesive close to fire.
Use alcohol, liquid gasket, or adhesive while ventilating the room.
Wear protective gear including a mask, protective goggles, and oil-
resistant gloves.
CAUTION
If alcohol, liquid gasket, or adhesive gets on your skin, wash the area
thoroughly with soap and water.
If alcohol, liquid gasket, or adhesive gets into your eyes or mouth, flush
your eyes or wash out your mouth with clean water thoroughly, and
then see a doctor immediately.
16 Safety Manual Rev.4