Installation; Notes On Safety For The Installation; Handling; Preliminary Checks - Riello PRESS 30 N Installation, Use And Maintenance Instructions

5

Installation

5.1

Notes on safety for the installation

After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the
environment, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
5.2

Handling

The burner packaging includes a wooden platform, it is therefore
possible to move the burner (still packaged) with a transpallet
truck or fork lift truck.
The handling operations for the burner can be
highly dangerous if not carried out with the
greatest attention: keep any unauthorised people
WARNING at a distance; check the integrity and suitableness
of the available means of handling.
Check also that the area in which you are working
is empty and that there is an adequate escape
area (i.e. a free, safe area to which you can
quickly move if the burner should fall).
When handling, keep the load at not more than
20-25cm from the ground.
5.3

Preliminary checks

Checking the consignment
After removing all the packaging, check the
integrity of the contents. In the event of doubt, do
not use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or
cardboard box, nails, clips, plastic bags, etc.)
must not be abandoned as they are potential
sources of danger and pollution; they should be
collected and disposed of in the appropriate
places.
Checking the characteristics of the burner
Check the identification label of the burner.
A burner label that has been tampered with,
removed or is missing, along with anything else
that prevents the definite identification of the
WARNING burner makes any installation or maintenance
work difficult.
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and
WARNING regulations of the laws in force.
Combustion air inside the boiler must be free from
hazardous
halogen); if present, it is highly recommended to
DANGER carry out cleaning and maintenance more
frequently.
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
carefully clean all around the area where the
burner will be installed.
CAUTION
9 GB
mixes (e.g.: chloride, fluoride,
20132157