Restoring All Default Settings - Furuno NX-700A Operator's Manual

3. MAINTENANCE & TROUBLESHOOTING
8. When the message "Hit any key" appears on the screen, press any key
(except
The alarm for receiving monitor sounds while the Rx test is being conducted.
Also the test message is printed when the item other than "None" at Printer on
System menu.
9. When the message "Hit any key." appears on the screen, press any key
(except
10. Press the MENU/ESC key several times to close the menu.
3.5

Restoring all Default Settings

This operation restores all default settings. The following two settings, however,
are not disturbed.
-Received messages
-NAVTEX stations list (See paragraph 2.13.)
1. Press the MENU/ESC key to show the main menu.
2. Press ▼ to choose Service, and then press the ENT key.
3. Press ▲ or ▼ to choose Default Setting, and then press ENT key.
The message "Restore default settings?" appears.
4. Press ◄ to choose "Yes", and then press the ENT key.
The Service menu appears.
5. Press the MENU/ESC key several times to close the menu.
3-6
key) to show the Rx test screen.
key) or wait for one minute with no operation to finish.
Rx test