Restoring To Defaults (Reset); All Reset; Memory Channels Reset; Aprs Reset - Yaesu FTM-200DR Operating Manual

When the All Reset function is performed, all data registered in the memory will be deleted. Be sure
to note the settings on paper or back up the data on a microSD memory card.

All Reset

To restore all transceiver settings and memory content to the factory defaults.
1. Press and hold the [F menu] key.
The Setup Menu screen will be displayed.
2. Press the DIAL knob to select [124 FACTORY RESET],
then press the DIAL knob.
"FACTORY RESET" appears on the LCD.
3. Rotate the DIAL knob to select [OK].
To cancel the resetting, select [CANCEL], then press the DIAL knob.
4. Press the DIAL knob to reset all.
After resetting all defaults, the call sign input message appears on the LCD. Set the
call sign (page page 4).

Memory Channels Reset

To erase only the registered all memory channels.
1. Press and hold the [F menu] key  [119 MEMORY CH RESET]
"MEMORY CH RESET" appears on the LCD.
2. Rotate the DIAL knob to select [OK].
To cancel the resetting, select [CANCEL], then press the DIAL knob.
3. Press the DIAL knob to delete all memory contents.

APRS Reset

To restore all APRS settings to the factory defaults.
1. Press and hold the [F menu] key  [120 APRS RESET]
"APRS RESET" appears on the LCD.
2. Rotate the DIAL knob to select [OK].
To cancel the resetting, select [CANCEL], then press the DIAL knob.
3. Press the DIAL knob to delete all APRS settings.

Restoring to Defaults (Reset)

Caution
RESET
121 CONFIG SET
122 CONFIG RECALL
123 SOFTWARE VERSION >
124 FACTORY RESET
>
75