Daikin VAM-J8 Series Manual page 13

VAM350~2000J8VEB
Heat reclaim ventilation unit
4P664012-1 – 2021.08
3
WARNING
▪
All wiring MUST be performed by an authorised electrician and MUST comply
with the applicable legislation.
▪
Make electrical connections to the fixed wiring.
▪
All components procured on-site and all electrical construction MUST comply
with the applicable legislation.
WARNING
▪
After finishing the electrical work, confirm that each electrical component and
terminal inside the electrical components box is connected securely.
▪
Make sure all covers are closed before starting up the unit.
WARNING
If NOT factory installed, a main switch or other means for disconnection, having a
contact separation in all poles providing full disconnection under overvoltage
category III condition, MUST be installed in the fixed wiring.
WARNING
▪
ONLY use copper wires.
▪
Make sure the field wiring complies with the applicable legislation.
▪
All field wiring MUST be performed in accordance with the wiring diagram
supplied with the product.
▪
NEVER squeeze bundled cables and make sure they do NOT come into contact
with the piping and sharp edges. Make sure no external pressure is applied to the
terminal connections.
▪
Make sure to install earth wiring. Do NOT earth the unit to a utility pipe, surge
absorber, or telephone earth. Incomplete earthing may cause electrical shock.
▪
Make sure to install the required fuses or circuit breakers.
▪
Make sure to install an earth leakage protector. Failure to do so may cause
electrical shock or fire.
CAUTION
Before opening the cover, be sure to turn off the power switches of the main units
and other devices connected to the main units.
▪
Remove the screws that secure the cover and open the switch box.
▪
Secure the power supply cable and the control wire with a tie wrap, as shown in
the figures.
WARNING
If a gap is present at the cable entry, wrap the cable (or cables) with the sealing
material from the accessory bag.
This will prevent small objects (such as children's fingers, ... etc.) as well as fluid
droplets from entering the unit.
+
+
Specific installer safety instructions
|
=
=
Installer and user reference guide
13