Furuno 2167DS-BB Installation Manual page 4

WARNING
Do not open the equipment unless
totally familiar with electrical circuits
and service manual.
Only qualified personnel should work
inside the equipment.
Wear a hard hat and safety belt when
mounting the antenna unit.
Serious injury or death can result if
someone falls from the radar antenna mast.
Construct a suitable service platform
from which to install the antenna unit.
Serious injury or death can result if
someone falls from the radar antenna
mast.
Do not install units other than the
antenna unit in a place subject to rain
or water splash.
Fire, electrical shock or injury can result if
water leaks into those units.
Turn off the power at the switchboard
before beginning the installation.
Fire, electrical shock or injury can result if
the power is on during the installation.
Use only the specified power cables.
Use of power cables that are thinner than
those specified can cause fire.
Securely attach protective earth to the
ship's body.
The protective earth is required to prevent
electrical shock.
ii
CAUTION
A proper license is necessary to install
a radar.
See your dealer for details.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Standard
compass
Antenna Unit
4.30 m
(60 kw)
Monitor Unit
1.55 m
(MU-201CR)
Processor Unit
1.35 m
(RPU-013)
Control Unit
0.30 m
(RCU-014)
Control Unit
0.95 m
(RCU-015)
Control Unit
0.65 m
(RCU-016)
Power Supply
0.30 m
Unit (PSU-006)
Memory Card
Interface Unit
0.90 m
(CU-200)
Switching Hub
1.00 m
(HUB-100)
Monitor Unit
1.65 m
(MU-190)
Steering
compass
2.80 m
1.00 m
0.85 m
0.30 m
0.60 m
0.45 m
0.30 m
0.60 m
0.60 m
1.05 m